Yes I got my locks working again but it was a total fluke. Try disconnecting and shorting both battery cables. Even if I don't drive it and check it each of the 3-4 days. The main panel also has to be able to control the operation of other windows so all control for the windows starts from the main panel. All information on this site is the opinion of its members and not the opinion of the site itself. The electric door lock switch on the drivers door will lock the door. I have seen railroaders problem mine is the same what is the solution? I'm grounding it at the bottom of the door.
He bought the Stratus from one of those dealers that sells used rental cars. I hope you have the same dumb luck I had on this! Since the door locks don't work with either the switch or keyless, I don't suspect a fault with the body control module, which is also the keyless receiver. I have a 1986 Chevy Silverado K10 with auto door locks. . Back two haven't worked in 3 years, front two only by the drivers switch in all that time. All windows, locks and the passenger rear view mirror working except the driver side.Next
Can the Driver door module go bad where only certain doors quit working? A volt meter, available at any auto parts store, can be used to check the voltage to the individual lock solenoids and switches. If you checked the fuses, you can check power and ground at the window switch. Seems like an electrical problem. Everything was fine, then all of a sudden it quit! But the rubber boot is a pain to remove. The driver side switch works fine in controlling all functions except for the driver side including locking and unlocking, rear view mirror and all windows. Hm, normally the door switch fails. This is happening on a 1999 Ford F150.Next
Im finally fed up with it today someone actually ransacked my car and left all the doors wide open although they did not take anything. My car is a 2002 Honda Civic, I have researched this problem but have found nothing on the internet. For now, the panel is on there good enough. Sometimes door lock is up but door is locked resulting in alarm going off if door is opened before I hit the remote. The key will not turn to the unlock position. I stripped the wires and soldered them together and the three windows and locks all work now that didn't before. Any other area I need to test? About a year ago the power window for the driver side stopped working.Next
I unhooked the motor from the wires coming from the switch and applied direct power. Anybody fixed this problem already and can give me some direction this would be great. I did so, left it disconnected for about fifteen minutes, and tried again, still nothing. After that and still with no success, you will probably need a scan tool to verify inputs are being received by the drivers door module switch. Then you have broken wires in the door jamb that is causing your issues. Thank you so much for your help. Simple fix is to take the positive lead off your batter for about 30 mins or so and reconnect.Next
According to Mitchelle it takes a scan tool to go in and relearn the bcm. To lock the doors the switch provides voltage to the two terminals of the solenoid. The doors lock and unlock with the fob. Occasionally I get buzzing, but not all the time. The doors will not automatically unlock. I removed the fuse for several minutes and still the power door lock will not function. Try rapping on the door while pushing the up window button.Next
I know this is about 4 year later : but I came across this issue today with my H3 and found this thread while searching for solutions. Or if there is power to a none working door is it that door module that is bad? Now the pass rear door has power and everything works there, but i still have nothing at the front pass. Check out the diagrams below. Its only been having this problem for about a week now I had to take the battery and connect it to the power window motor to get the windows to roll back up. The door switch at the nader bolt is responsible for cutting the radio off when you open the door. Have you ever heard of such a thing? I can hear the locks working with both the remote and the door switches. Thank you for taking time to post your solutions to these problems; it sure does help! I read that when the battery gets weak then the computer shuts down nonessential electronics based on importance.Next
Had the same issue drivers door lock and power window not working and I read all of the solutions posted. The less resistance this whole assembly has the longer I believe it will last. All three doors went out at the same moment. It has stayed lock for a little while now and only the key fob can unlock it. My issue is with the front passenger side door. I tore the driver door apart and inspected all wires and found nothing apparent. You would need to used a voltage meter to check the supply voltage.